3 Ways to Improve the Performance of Your Solar Pump

Initialize the solar photovoltaic water pump

Any type of water pump, whether it is an ordinary water pump or a solar water pump, cannot pump water smoothly if there is air in the pump. In order to better initialize the water pump, the water pump can be completely immersed in the water to let the air inside out. This step will not take much time, but this step is very important. If you don’t have a water pump, you need to drain the water in the pump and the water pipe. When you use it again, you also need to initialize the pump.

Place the solar panel in a sunny place

Use solar energy as your energy source, which gives you more flexibility in choosing the installation location. But you should choose a sunny place so that your pump can work more fully. The longer the sun exposure at the installation point, the longer your pump system will work. When the sun is not enough, you can also use the battery drive system to work.

Keep the pool water clear and free of impurities

Most photovoltaic water pumps have filters. This is to prevent impurities from clogging the pump, but it is also necessary to keep the pool water as clean as possible with less impurities. Therefore, the cleaner the water, the higher the working efficiency of the photovoltaic water pump system and the longer the service life.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses cookies to offer you a better browsing experience. By browsing this website, you agree to our use of cookies.